( 14 reviews )
-
Posted: Jan 17 2009
The DWL2100AP worked OK as an access point, but does not work as a repeater. Other reviewers suggest that it works only with other D-Link products, because of proprietary protocols. All I know is I wasted a lot of time trying to get it to work as a repeater, and was unsuccessful. I bought a Hawkings repeater, and had it working in 15 minutes. If you need an access point, you can find a cheaper one. If you need a repeater, buy something else.
-
Posted: Nov 17 2008
Purchased 2 DWL-2100AP's to use as a bridge between 2 buildings with an unobstructed distance of about 750ft. I was expecting the usual 2-day setup headache to integrate these into the network, but to my surprise the 2100AP worked perfectly once the initial configuration was completed. Plugged in an old Linksys WAP54g to the far end of the bridge and created a greatly expanded network. Total setup time took less than 1 hour. I have not measured data transfer, but it seems very good. No problems with streaming video, etc. The instructions for the 2100AP are a little sketchy, and D-link seems to interchange some technical terms that mean the same thing (adds color and confusion to their writing!). However, I did not find the instructions any worse than the several Linksys or Netgear Wireless Routers that I have installed over the past couple of years. If we get a couple of years out of these, for the price, I'll be happy. It seems like there is no middle of the road wireless equipment. Either it is really cheap of dubious quality or really expensive. Someone needs to come out with some equipment that is of better quality at a reasonable price.
-
Posted: Mar 7 2008
I have a d-link router (DI-624) that I use for my wireless network. I wanted to install this access point on the network, attach a switch, and provide network access for a home-theater pc and an Xbox 360. modem router ... accesspoint switch pc & xbox The access point can operate in five different modes. After some trial and error, I finally figured out that it was the "AP Client" mode that I needed from the wireless setup options to gain access to my existing wireless network. After plugging in the switch and attaching the PC and Xbox to the switch, it was soon obvious that only the PC had connectivity. After much hair pulling, I finally found a post on dslreports.com by one lizi555 that explained a fix. Apparently the latest firmware (beyond 2.10) does not allow for more than one device (MAC address) to connect to the network via the switch. To fix, telnet to the 2100AP's IP address 192.168.0.50 and enter the following commands -> set matstate 1 then -> reboot This should set a flag for a variable to the following "MultiEthClient (Yes)!" You can check by establishing another telnet session and entering -> get matstate which will list several variables/values including the one above. It took some doing, but now everything is flowing sweetly. I hope this helps anyone else that runs in to this problem.
